potentiometer and jumpers - CNCzone.com-The Largest Machinist Community on the net!

droddis · #1 02-26-2008, 12:26 PM

Hi i need to set the potentiometer and jumpers on my cnc board, but i have lost the instructions could anybody explain how i do this.

I am using the 3 axis board
and the 8wire 1.85Nm from motion control products.

Thanks
David

mike@mikebeck.o · #2 02-26-2008, 05:52 PM

Hi, David,

There are different settings for different boards. What board and Rev, (revision), number, do you have? Also, it would help to know about how old it is. Given that info, I've probably got the instruction sheets that has the info you need.

All the best
MB

droddis · #3 03-02-2008, 10:58 AM

Sorry, its the 3axis hobbycnc pro rev 1.

Thanks
David

mike@mikebeck.o · #4 03-02-2008, 01:53 PM

Dave,

If you have a first-run board, the info is printed right on it. If current run, after first of the year, it's not. I'll type it all out for you.

MB

droddis · #5 03-04-2008, 11:25 AM

Hey thanks, i did some digging around and found instructions, Thanks for your help.

David

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
x2 potentiometer possibly bad, help	h_2_o	Benchtop Machines	9	12-12-2006 10:18 PM
4th Axis Prewired (Jumpers)	Fudd	Fadal	1	02-17-2006 06:21 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)