Hearing Static noise but no movement - CNCzone.com-The Largest Machinist Community on the net!

10-14-2007, 08:26 AM

Hmedich

Join Date: May 2007

Location: egypt

Posts: 6

Hearing Static noise but no movement

permalink

Hi all
I need some help in my first project please.
I purchased 3 axis board with (3) 305oz-in 4.2V 3A Steppers
and i have follewed the installion steps as it was writen in the papers with the package,but after that when I turned it on the motors didn't lockup also I am hearing little noise.

what can i do to make move ar to check if i made some mistake.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
static from hell	swarfmacdaddy	General Electronics Discussion	8	02-15-2010 01:09 PM
Static???	Mike Boarman	Mach Mill	1	06-10-2007 08:19 PM
Static Electricity	jgro	Safety Zone	19	05-30-2007 12:02 AM
static supporting shafts, y?	max_imum2000	Linear and Rotary Motion	3	01-18-2006 01:28 PM
static & dynamic load ?	mdreitzusa	Mechanical Calculations/Engineering Design	17	12-13-2005 05:03 AM

All times are GMT -5. The time now is 08:44 PM.