| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-31-2007, 06:19 AM
| |||
| |||
I have an interest about Hobby CNC controllers. I have some questions. What is diffrencies between HOBBYCNC PRO Chopper Driver Board Kits and 4AUPC ? Thanx for your interest.  |
|
#2
01-31-2007, 09:52 AM
| ||||
| ||||
| With most stepper drivers, if you disconnect a motor wire while the unit is powered up, it will fry the driver chips, rendering the board useless. The Pro model has a built in protection circuit, whereas the 4AUPC does not, it is an older model. The Pro board also runs a LOT quieter. Spend the extra 20 bucks if you are looking at purchasing a board, and get the PRO.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) "If the women don't find you handsome, they should at least find you handy" -RedGreen show. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What Is your interest in CNC? | widgitmaster | Polls | 30 | 04-02-2009 09:19 PM |
| my site may interest you | vacpress | CNCzone Club House | 7 | 05-31-2006 01:51 PM |
| Any interest in cnc Boxford's? | greggv | General Metal Working Machines | 9 | 03-31-2006 12:53 PM |
| What are your other interest? | CNCadmin | CNCzone Club House | 40 | 05-23-2005 05:11 PM |
| Would this interest anyone? | DAB_Design | Employment Opportunity | 13 | 06-22-2004 08:21 AM |
| | |
Linear Mode
