Hobbycnc controller

[jimini]

Hi Gang
My first router has a hobby cnc controller( at least 2 years old) based on the 5804 ic and I need the pinout or schematic for it.
Does anyone have a copy of the schematic. It's too difficult trying to trace the pinouts 'cause I have it hardwired into the box.
Is Dean of Hobby cnc the same as Dean of Axxus?
Thanks..............Jim

[wjbzone]

Jim,
If your hobbycnc board is the same as mine, here are the pinouts:

X step 2
X dir 6
Y step 3
Y dir 7
Z step 4
Zdir 8
Gnd 24
X home 11
Y home 12
Z home 13
Limit 10

Bill.

[Budcan2]

Hi Jim

It was Deans Hobby CNC before he changed it to Axxus Technology a couple of years ago.
Dean lives in Edmonton, Alberta, Canada

Joe

[Budcan2]

Hi Jim

Dean was Deans Hobby cnc before he changed the name to Axxus
Technology a couple of years ago.
Dean lives in Edmonton, Alberta, Canada.

Joe

[jimini]

Thanks a lot I found it was setup for Dancam.

[jimini]

One more thing I'm looking for is a schematic for a parallel port breakout board similar to the one Axxus has.
If anyone knows where I can find one please let me know........................Thanks again...Jim

[Mr.Chips]

EAS has a breakout board for $5.00 (bare).
http://www.embeddedtronics.com/

Go to the "Microstep" then select "breakout board".

They show the schematic but for $5.00, I baught it. The parts list is shown which shows the DigiKey PN, for convience. Or you could buy the on board connectors from a good electrical supply. They don't sell a populated board.
Hope this helps.
Hager