| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-03-2006, 08:15 AM
| |||
| |||
I am about ready to order the kit, however, in the description 35vdc recommended, but the transformer recommened is only 24v? Is there a different transformer that should be used? Thank you Stephen    |
|
#2
05-03-2006, 08:19 AM
| ||||
| ||||
| 24vac results in a little over 30vDC when rectified. 24x 1.414 - ~ 1.5 Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
