| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-22-2006, 12:59 PM
| |||
| |||
I would like to know if I increase the voltage going to a stepper motor will it increase the power. I need more torque. Anyone with any ideas on how I can make a 400 oz inch motoring into about 600 oz inch. Thank you    |
|
#2
03-22-2006, 01:06 PM
| ||||
| ||||
| gear it down, but it'll go slower. More voltage = higher speed.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
