| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
09-07-2005, 12:35 AM
| ||||
| ||||
Anyone know what is the pin that is used for running the Auto Heat Control? The instructions don't say. I'm using foamworks software BTW.
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com    |
|
#2
09-07-2005, 06:33 AM
| |||
| |||
Page 3 of the assembly instructions have what you seek under the section labeled: "Interfacing with the printer port" Dave Rigotti HobbyCNC.com |
|
#3
09-07-2005, 08:02 AM
| ||||
| ||||
| OK I see it- Parallel Port Pinouts are as follows: 2=LY dir 3=LY step 4=LX dir 5=LX step 6=RY dir 7=RY step 8=RX dir 9=RX step 10=Timer 11=Heat Feedback 12=Auto/Man Heat Control 16=Heat 18-25= Ground All others are not connected
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
