| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-19-2005, 03:11 PM
| |||
| |||
I had to turn off the machine partway thru a pattern because a piece I was cutting came loose and was going to jam the router. Now for the problem. There seems to be no power to the board , not even the fan turns on. I can see no visible damage and have replaced the fuses just in case and rechecked all the wires. What could be the problem and how do I check for errors? The chips seem visually undamaged.What have I done wrong? Your help would be appreciated.    |
|
#2
08-19-2005, 03:20 PM
| ||||
| ||||
| Have you verified that the board is seeing power with a volt meter? The driver chips may not show any visible damage.
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
