Mastercam,EMC Hobbycnc - CNCzone.com-The Largest Machinist Community on the net!

k-linkz · #1 06-20-2005, 11:26 PM

Hi ,
i just bought the card hobbyCNC with a 3D chipframe.
I new it to this. I know martercam and EMC a little but do you manage to
start this the CNC programme after you have finish verifid it? where is the connect or setup programme for the protocole???

HobbyCNC · #2 06-21-2005, 05:48 AM

Originally Posted by k-linkz

Hi ,
i just bought the card hobbyCNC with a 3D chipframe.
I new it to this. I know martercam and EMC a little but do you manage to
start this the CNC programme after you have finish verifid it? where is the connect or setup programme for the protocole???

The hardware pinouts are identified in the instructions that were included with the driver board.

Dave Rigotti
HobbyCNC.com

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Advice / help? - HobbyCNC upgrade for SpectraLight 0200	Sporqster	Hobbycnc (Products)	1	06-15-2005 10:55 PM
HobbyCNC vs Xylotex (prices)	Chunky	General Electronics Discussion	0	06-14-2005 09:46 PM
HobbyCNC	Electech	Hobbycnc (Products)	0	03-09-2005 01:17 AM
HobbyCNC 3 axis board build and review	Jay C	Hobbycnc (Products)	19	02-18-2005 11:22 PM
hobbycnc board	wjbzone	General Electronics Discussion	5	08-23-2003 10:25 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)