| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobbycnc (Products) Discuss Hobbycnc controller boards here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-21-2010, 01:29 AM
| |||
| |||
I was checking my vRef settings on my pro board and the X and Z axis' were fine, but the Y axis I cannot get higher than .20 volts (1.45 amps~). I am running 200 oz. stepper motors from HobbyCNC and they are rated for .42 vRef or 3 amps. Not sure where the breakdown in the board could be, has anyone else run into this?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surface finish problem - Could you please help me overcome this problem? | DMBGO | EMCO Lathe | 5 | 08-04-2010 05:33 PM |
| machine problem or software problem? | bcnc | Syil Products | 8 | 10-26-2009 09:51 AM |
| Setting Vref---when? | monte55 | Xylotex | 2 | 10-25-2006 07:55 AM |
| Vref setting | CnC_BoY | Xylotex | 1 | 04-15-2006 03:47 PM |
| | |
vRef Problem 
Linear Mode
