- Need Help!- All axis move one direction
-
Member
All axis move one direction
I have stepper motor and breakout board , i had purchase it from china
then when i connect it with PC , and mach3
tried many time to move direction, but no way, it just move to one way
i change every wire and double check it
when i try to move motor to other direction
i changed breakout board
i changed PC ( For change parallel /port )
i changed mach3 program
tried every thing can , but no thing change
Pls any one have any ideas
be note am new in this
Similar Threads:
-
-
Member
Re: All axis move one direction
Check the direction output, does it change from a Low to High or High to Low when you switch directions. You probably do not have the Port and Pin set correct for the direction output pin for each axis.
Russ
- Need Help!- All axis move one direction
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules