Need Help! All axis move one direction

Results 1 to 2 of 2

Thread: All axis move one direction

  1. #1
    Registered
    Join Date
    Dec 2015
    Posts
    1
    Downloads
    0
    Uploads
    0

    Unhappy All axis move one direction

    I have stepper motor and breakout board , i had purchase it from china
    then when i connect it with PC , and mach3

    tried many time to move direction, but no way, it just move to one way

    i change every wire and double check it
    when i try to move motor to other direction
    i changed breakout board
    i changed PC ( For change parallel /port )
    i changed mach3 program

    tried every thing can , but no thing change

    Pls any one have any ideas

    be note am new in this

    Similar Threads:


  2. #2
    Registered
    Join Date
    Jun 2005
    Location
    USA
    Posts
    1221
    Downloads
    0
    Uploads
    0

    Default Re: All axis move one direction

    Check the direction output, does it change from a Low to High or High to Low when you switch directions. You probably do not have the Port and Pin set correct for the direction output pin for each axis.

    Russ



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

All axis move one direction
All axis move one direction