I believe that you can plug a HobbyCNC directly into the Smoothstepper.
Do mach3 smooth steppers or motion controllers require a stepper driver for each motor? Im running a hobby cnc board that was 45$ and its the size of a small breakout board and doesnt require drivers. However if its discontinued ill need a new solution
Similar Threads:
I believe that you can plug a HobbyCNC directly into the Smoothstepper.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
The Smoothstepper is not a stepper driver, so yes, you still need a drive for each motor.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)