Well here goes
First off I'll say hi as this is my first post, still finding my feet around here havent had enough time lurking to see where everything is at.
I am a CNC programmer/setter so I am sure I will come in handy at some point. What I am after though is a little bit of a nudge in the right direction on building my own CNC. The biggest deal for me is going to be able to source the linear slide and ball screw at a price thats good.
I am pretty sure thats everyones problem though.
I already found this little gem on ebay....
Seems to be pretty nice, although I am sure one or 2 of you guys may be able to tell me if its ideal for an X-axis or not. From all the research I have been doing the Nema 23 seems to be the favourite choice I am not too sure if it would have the poke needed to drive that, any ideas appreciated very much so