| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobby Discussion Discuss other CNC-related Hobbies here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-20-2011, 02:18 PM
| |||
| |||
Hi all Does anybody have any experience with these, ie are they any good. I have already been stung by the toshiba board that lasted about 15 mins so now i want to get something a bit better. Should I get these or are they just as bad Best regards Edd  |
|
#2
10-19-2011, 12:17 PM
| |||
| |||
| Hi, I've got the Leadshine M542 driver at the moment, which looks identical to the 2m542 but I'm not sure if they are cheaper components or not, something i would like to find out on that front. But if anything is to go by on the Leadshine driver, so far it's a good driver and works well. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- JMC-2M542-N | ahab8783 | Hobby Discussion | 3 | 07-20-2011 02:25 PM |
| Need Help!- Power supply for three JMC-2M542 driver boards | ahab8783 | RC Robotics & Autonomous Robots | 1 | 07-08-2011 10:31 PM |
| Need Help!- 2m542 driver flashing red | ezewax | Stepper Motors and Drives | 2 | 03-22-2011 12:56 AM |
| what controller with this Driver | cozymkiv | General CNC (Mill and Lathe) Control Software (NC) | 0 | 08-06-2006 09:46 AM |
| DeskCNC Controller/driver | rogerbureau | DeskCNC Controller Board | 0 | 01-18-2005 02:30 AM |
| | |
Linear Mode
