![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hobby Discussion Discuss other CNC-related Hobbies here. |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
| |||
| |||
Hey all - does anyone know where i can get my hands on 3 way solenoid valves? I'll be using compressed air, up to 50-60 psi. I can find them new for about 20 dollars. I've not found a good surplus site that sells them. I tried looking at washing machine solenoids but those all seem to be 30 bucks or so and would have to be hacked on a bit to use. Thanks! Shane |
|
#2
| ||||
| ||||
| I've never seen them for much less than $20 anywhere. I check Surplus Center often, but have never seen any really good deals.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
| |||
| |||
| I've had really good luck with Ebay...I look for lots (groups) or whole assemblies...for pneumatics you can get dump valve with lockout, inline solenoid, nice large filter bowl, oil/mist filter, and regulator all connected right off some industrial machine, etc. Best of luck! Chuck http://www.cnczone.com/forums/images...s/asthanos.gif |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| source for oxygen solenoid? | blobue | Torchmate | 0 | 08-03-2010 12:54 AM |
| Enerpac VS3 and VS4 solenoid valves FS on eBay! | Edster | EBAY ADS | 0 | 06-10-2009 05:40 PM |
| Problem- Inexpensive Solenoid Valves | greenchair | RC Robotics & Autonomous Robots | 1 | 09-23-2008 08:59 AM |
| source for inexpensive 3-d probe? | cncuser1 | Digitizing and Laser Digitizing | 11 | 11-16-2006 03:32 PM |
| Need a good/inexpensive motor& speed controller | sleepy23 | Mini Lathe | 2 | 07-05-2006 12:36 AM |