Need Help!- I need help finding someone to do some CNC work in New york area

[coralcrazed]

Hello,

I wasn't sure where to post this so I hope this is a good enough place under the general tab. I am working with 1" thick, 1/2" thick and 1/4" thick acrylic sheet that I need to have cut with a proper CNC machiene. The project will be made up of rectilinear pieces and components that must fit together acuratly. I have drawn it on AotoCad as well so its all layed out and can provide whatever drawing a machenist needs to plug into thier CNC computer. I would also like to purchase the acrylic from the same place as well. looking for Polycast cast acrylic sheet for the 1" and 1/2", the 1/4" can be less expensive grade. 1" will be clear, 1/2" will be black and 1/4" will be a combo of red and clear.

can you help me find a good CNC machienist in the NY area approx 1/2 hour north from NYC. I will also travel upto 1 hour from my westchester home. thanks so much for your help. also I will need about 50 or so pieces cut can you give me an idea how much I should be looking at for this type of project?

[coralcrazed]

any help would be appreciated greatly.

[jalessi]

Coralcrazed,

You might have better luck posting in the RFQ section of the forum.

http://www.cnczone.com/forums/employment_opportunity/

You may receive better pricing if you allow others to bid that are not in your area, the goods could be shipped.

Welcome to the Zone,

Jeff...

[wdrichardson]

I came across your post and I beleive i will be able to help you. I have a 4 axis cnc table of 4x8ft. This table will cut wood, plastic, foam, and sheets of rubber with a rotary cutter. If your interested in me helping you, send me more detail and dimensions of your needs. You can contact me via email.

Willie D Richardson
wrichardson@comsouth.net