- Newbie- CNC usingTrim router tip
-
Registered
CNC usingTrim router tip
One newbie to another hopefully a helpful tip. The software like Vetric, etc. are setup for spindles, I'm using a trim router. I learned turning the feed speed to 30 for hogging out is the max. I have made lots of mistakes learning, my scrap pile is bigger than my good ones lol. Hardwood I wood even go down to 20. Hope this is helpful
Similar Threads:
-
- Newbie- CNC usingTrim router tip
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules