Hello docdesigns,
I have the same problem with these lathe, i know how to changue the parameter K00.3, do you have exactly the bit that need must changed?
The button combinations are Stop Spindle, Select button and feed hold at the same time.
Hi All,
* I have 1998 Hitachi Seiki TS15 with seicos sigma 21 control.* I recently had the timing belt in the turret start to fray and the belting was pulled from within the middle of the belt wrapping around the pulleys causing it to not index correctly and causing a turret index time out alarm.* I was able to clear the belting and get it working again without removing the whole turret disc and was able to continue using it while I waited for a new belt to come until it happened again for the same reason.* I removed the "tool turret disc"* and get the old belt off and replace it with a new belt.* However, the timing is now off when I index the turret so it wont clamp correctly.* I still have it apart.*
I cannot find the correct procedure to reset the timing of the turret in my manuals.* Online it seems different models of hitachi seikis use different 3 button combinations and procedures to reset this.* I have seen that I may need to change the 1815 parameter possibly and something else K00.3?
Does any one know the correct procedure on this lathe?* Any help would be greatly appreciated.
Thank you
Similar Threads:
Last edited by docdesigns; 08-27-2017 at 10:57 AM.
Hello docdesigns,
I have the same problem with these lathe, i know how to changue the parameter K00.3, do you have exactly the bit that need must changed?
The button combinations are Stop Spindle, Select button and feed hold at the same time.
That is a keep relay - so you have to go to Keep Relay 00 and change bit 3 from a 0 to a 1. PM me if you need more help and I can send you a procedure on how to fix this
John
Can you send me the procedure please?
k45h@live.com
Thank you!
Sent - take a look and let me know how it works out
John
Hi,
I need this procedure too, can anyone send it to me?
Thanks
I have the same issue. Can someone send me the procedure? Thanks
john can you send me the reset procedure?
Send me a PM with your email and I’ll send you you
Sent from my iPhone using Tapatalk
have you received my pm?
if you can send me an email to arthugot@gmail.com
Hello
procedure sent! Take a look and let me know that it worked
John
john I cant change parameter 1815. how can i do that?
Hi can you send it to me as well mikkib79@hotmail.co.uk
Cheers
no mather what I do I can't change parameter 1015 from 2 to 4
Figured out, at the Set Button I have enabled parameter write and all worked good. Thank you John, I owe you a beer !! Machine up and running !
Hi can you send me the procedure as well please to mikkib79@hotmail.co.uk
Cheers
Hi John, It looks like you have a lot of knowledge of Hitachi-Seiki's. I have an HT23J. The tool unclamp/clamp piston hit the hydraulic tool release piston while the turret was indexing, & stopped the turret. I don’t know how to get it back to zero. Can you help me with the procedure to zero it?
Its a Hitachi-Seiki HT23J with a Yasnak control.
Thank you
Mike