| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hardinge Lathes Discuss Hardinge Lathes here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-06-2010, 02:22 PM
| |||
| |||
When defining the part profile for the G73 Pattern Repeat cycle, is it okay to use the angle, chamfer and radius addresses (,A ,C ,R) or must it be done using G1, G2 and G3? Thank you for any help!  |
|
#2
01-06-2010, 03:33 PM
| ||||
| ||||
| "U, W, I, K, R" definitely "A" & "C" should as well. What you need to do is a simple profile with those designations. If the control is capable you won't get any alarms. 
__________________ Toby D. "Imagination and Memory are but one thing, but for divers considerations have divers names" Schwarzwald (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) www.refractotech.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- FANUC 10T G76 cycle | DanilGrip | Fanuc | 10 | 03-03-2010 07:51 AM |
| Fanuc OT-C and G71 Cycle | rrbmachining | Fanuc | 7 | 11-24-2009 04:55 AM |
| Need Help!- Hardinge TT-65 w/ Fanuc 18i-T | Jeff_Mezzo | Hardinge Lathes | 3 | 01-28-2009 08:24 PM |
| Need Help!- fanuc gn6tc hardinge | fcycles | Fanuc | 3 | 01-28-2009 03:27 PM |
| Hardinge Cobra42 w/ Fanuc 21-T | danohpsp | Fanuc | 0 | 11-30-2007 11:14 PM |
| | |
Linear Mode
