Sameca-built Harmatic Feeder - CNCzone.com-The Largest Machinist Community on the net!

beege · #1 07-07-2009, 10:16 AM

I have a Harmatic 12 foot barfeeder. Model MOS.45, Serial # 2-190. Would anyone have electrical schematics for it? Any special interface notes, like HIB jumpers? I have one that won't come out of alarm on my Hardinge CHNC II+, and I'd really like to get it running.

jayeff1 · #2 11-03-2010, 03:58 PM

We have a Harmatic 765, that we have struggled with interfacing on three different Hardinge model/control combinations - and have ben searching for more information on the electrical interface.
Were you ever successful in getting your bar feeder hooked up to the CHNCII+?

Thanks -

beege · #3 11-03-2010, 05:18 PM

I did finally get it working, but have since sold the machine. This model needed a manual "boost" to get the pressure up before resetting the machine's alert.

jayeff1 · #4 11-04-2010, 07:13 AM

Thanks for the reply

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
when was it built?	Dar	Bridgeport and Hardinge Mills	2	04-14-2007 01:12 PM
How I built my CNC	scheek	DIY-CNC Router Table Machines	2	03-01-2007 07:58 AM
has anyone ever built one of these...	savvypower	I.C. Engines	0	02-11-2007 03:56 PM
Here is the DIY I built.	ljoe1969	CNC Wood Router Project Log	4	02-28-2005 04:42 PM
Built it, need help using it!	Lionclaw	DIY-CNC Router Table Machines	7	01-12-2005 10:25 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)