| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hardinge Lathes Discuss Hardinge Lathes here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-17-2009, 02:42 PM
| |||
| |||
| Spindle Encoder on HC Retrofit First post here, I have an HC retrofited with a Bandit control. Unfortunately, there is some damage I need to address. First thing right now is the wires going into the the spindle encoder got pulled out of the connector. I was hoping someone might have the same setup and be able to tell me which color wire goes to which pin so I can re-solder them. Thanks, Greg B.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Spindle encoder | Mark Hockett | Fadal | 9 | 03-17-2008 04:27 PM |
| SX3 spindle control retrofit? | Greolt | Syil Products | 13 | 02-07-2008 08:20 AM |
| spindle encoder | heilcnc | LinuxCNC (formerly EMC2) | 1 | 09-10-2007 10:12 AM |
| HELP..retrofit interact 4 spindle drive? | camarogod98 | Bridgeport and Hardinge Mills | 7 | 01-22-2007 05:12 PM |
| Encoder Retrofit To Baldor Servo | bgolash | Servo Motors and Drives | 1 | 03-22-2006 09:40 PM |
| | |
Linear Mode
