Need Help! Hardinge GS 250 tailstock - CNCzone.com-The Largest Machinist Community on the net!

dcskid · #1 04-15-2009, 10:32 AM

Our tailstock quill overtravelled. But it did not hit the limit switches. It just came out until we saw a red part on the lower shaft and stopped. No alarms. Now we cannot get it to withdraw the quill. We even pushed the quill back in over an inch and ot still will not reset. Any Ideas?

Thank you, David

dcskid · #2 04-15-2009, 10:47 AM

I have been here 2 years. For the first time since I have been here, our maintenance man actually did maintenance work and fixed it. Sorry to waste your time

g-codeguy · #3 04-15-2009, 12:18 PM

Originally Posted by dcskid

I have been here 2 years. For the first time since I have been here, our maintenance man actually did maintenance work and fixed it. Sorry to waste your time

Boy, wish I could make that much per hour!!!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Centerdrilling for tailstock	penjas14	General Metal Working Machines	1	01-14-2009 09:49 AM
Problem- sl-30 tailstock	travis1	Haas Lathes	0	11-04-2008 11:32 AM
tailstock won't extend	burnin daylight	Daewoo/Doosan	0	03-19-2007 04:35 PM
TL-2 tailstock	rbest27	Haas Mills	2	11-10-2006 06:20 PM
power tailstock	Runner4404spd	Mini Lathe	5	08-28-2006 08:27 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)