It has been a while since i fired up this machine. I moved it and powered it up yesterday and it seems that i got the wiring correct as the coolant pump is working and pumping coolant and the collet opens and closes. When i bring the machine out of e stop with the reset, it sounds like the boards are energizing in the mag panel in the back, but the drives are not turning on. i have no power to the x..z..or the spindle. Is there a knowledgable chnc guy out there or a good service tech in the charlotte nc area that would like to try and get this old girl running? i would rather not go to morris machine south as when i have contacted them before, i ask them a question..they e mail hardinge..two days later ..they get back to me.. they just don't have the experience level that it will take to fix my problem..