| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hardinge Lathes Discuss Hardinge Lathes here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-08-2012, 06:16 PM
| |||
| |||
THIS MACHINE WAS JUST PURCHASED.MACHINE OPERATED WHEN I PICKED UP.GOT IT HOME AND WIRED. PREVIOUS OWNERS LEFT PROGRAMS IN MACHINE.HOMED MACHINE AND UPLOADED A PROGRAM,PUSH CYCLE START SPINDLE STARTS AND MACHINE GOES IN TO HOLD MODE AND I GET A MESSAGE NO DATA TRANSFER. WHAT AM I DOING WRONG. THANKS GUS  |
|
#2
01-08-2012, 08:58 PM
| |||
| |||
| Gus It has been a while since I programmed ours, There a lot of reasons for that error from a simple programing error to a bad board it the control. The one I got frequently was not ending a sub routine with an M17 instead of the M99 that most controls use. I will ask my son on Monday if there are any more progaming reasons for this error. Hope this helps Mark |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Portable CNC data transfer Box | xyzer | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 07-21-2011 12:53 AM |
| Need Help!- DATA TRANSFER FROM SCRATCH | 99bluemoon | General CNC (Mill and Lathe) Control Software (NC) | 1 | 06-19-2011 05:37 PM |
| Best way for data transfer? | pontiacg5 | Mazak, Mitsubishi, Mazatrol | 6 | 06-24-2010 01:32 AM |
| sinumrik 810t data loss | suresh patil | Machine Problems, Solutions , Wireless DNC, serial port | 3 | 09-17-2007 02:57 AM |
| Torno CHNC I Problemas in monitor 810T | asantos | Spanish CNCzone | 3 | 09-11-2007 09:40 PM |
| | |
Linear Mode
