Chnc1 plc flash

[jacep]

Hi anyone out there have any luck flashing a Siemens 810t plc on a CHNC1?

I bought this machine about 6 months ago and the backup battery was dead. I talked to hardinge and had them send me the plc parameters, uploading instructions, and the wiring diagram for a 25 pin serial cable.

After replacing the battery, and checking the voltage on the small lipo battery soldered to the circuit board I still cannot get my desktop to communicate with the Siemens. I am using an old Dell optiplex with a 25 pin serial port and a SDNC program in a surfcam suite to transfer the data. I have followed the instruction, but cannot get Tea1, Tea2, and SEA to show up and confirm the transfer. Anyone have any ideas? The Hardinge service rep lives in colorado and would be pretty pricing to fly him out and install it.

[slane62]

Hi anyone out there have any luck flashing a Siemens 810t plc on a CHNC1?

I bought this machine about 6 months ago and the backup battery was dead. I talked to hardinge and had them send me the plc parameters, uploading instructions, and the wiring diagram for a 25 pin serial cable.

After replacing the battery, and checking the voltage on the small lipo battery soldered to the circuit board I still cannot get my desktop to communicate with the Siemens. I am using an old Dell optiplex with a 25 pin serial port and a SDNC program in a surfcam suite to transfer the data. I have followed the instruction, but cannot get Tea1, Tea2, and SEA to show up and confirm the transfer. Anyone have any ideas? The Hardinge service rep lives in colorado and would be pretty pricing to fly him out and install it.

Were you able to get every thing loaded back I have a complete reload of parameters and plc for this control even the software hardinge uses to load
you can email me at scottl62@charter.net