FANUC 18T, c-axiz not activating - CNCzone.com-The Largest Machinist Community on the net!

GTD222 · #1 08-12-2011, 03:41 PM

Hardinge T42 sp with fanuc 18t.
were trying to put flats on a diameter but keeps alarming out on M23. says improper M code. I need M23 to turn contour mode on though
any suggestions

joeski63 · #2 08-15-2011, 04:02 PM

I don't think that machine has that option,none of mine do

Spiker604 · #3 08-16-2011, 10:32 PM

If your machine has spindle orient you could just use that, try programming B 0.0, or B 45.0 or any other angle

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem activating Partmaster	deanq	Dolphin CADCAM	8	07-18-2010 04:43 PM
Installing and Activating	KT6G Radio	Dolphin CADCAM	6	02-28-2010 10:12 PM
Tool offset not activating	Danno	Dolphin CADCAM	3	01-12-2010 05:44 AM
servos not activating	Chris81579	Machine Problems, Solutions , Wireless DNC, serial port	1	03-11-2006 02:09 PM
Z-AXIZ weight	signIT	DIY-CNC Router Table Machines	8	07-01-2004 04:35 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)