chnc 1 control problems please help

[jacep]

I just bought a chnc 1 from a heavy equipment company that had this machine sitting in their warehouse for about 2 years. They said the machine was up and cutting when they got there to disconnect the machine. When I got the machine hooked up it gave me the control battery error too low so I put a new battery in and now nothing even comes up on the monitor. on the back of the controller (siemens) a nc fault light is on. When I put the old battery back in the controller it boots up and say's the battery too low replace to continue.

Did I lose all my memory? anyone ever reinstall all the flash?


thanks

[g-codeguy]

I'm not maintenance, nor familiar with that control, but it is quite possible you lost everything. I can't speak from experience, but I've been told that is why you change the battery with the power on. Did you?

[asantos]

yes you lost everything, I have the parametros and the instructions and the program, if you need it, send me you email and I send to you.

this is my email
tooldiecomp@yahoo.com