Superslant turret Air motor

[A1CNC]

I finally got my superslant running. Turns out it was a bad relay keeping it from going ready.

I crashed the turret during set-up. After hitting reset, jogging the tool off the part all seemed fine.

I was running some parts yesterday and all was well, in fact I ran ~10 parts with 2 tolchanges per part. Suddenly the turret wasn't rotating. it will lift, and if I manually rotated it to position it would lock down

Anyone know how much for the air-motor for the Turret and where to get one? The shaft in the planetary drive snapped.

Thanks

[nate]

is it the same motor as in a 1982 chnc 1? if so, I have one I might sell. I am going gang tooling and done need mine...

[A1CNC]

Hi Nate,
Thanks for the reply.
The part # is SB000933201.
It looks basically like an air ratchet with a bearing block and a gear on the end.
I will take a pictre later

Eric

[nate]

Email me at natefoerg @ Gmail dot com with the pic and I will look at mine and see if its the same.

[DouglasR]

that motor is hideously expensive from hardinge. I had a superslant 2 axis with fanuc 6Tb and had asked about that thing. if you can find it from somewhere else, you're better off.