| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hardinge Lathes Discuss Hardinge Lathes here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-11-2010, 06:07 AM
| |||
| |||
Help, I am trying to get my superslant going (new to me). I have an e-stop alarm from the spindle drive not closing the cr27 which is controlled by the field I am not sure what that means, but that is what the diagram tells me. This relay has 2 diodes across the coil. There seems to be power there if I check from the terminal to ground and the diodes get hot. The relay does not close though and I did try a different relay. The relay coil rings out with an ohm meter ( not open) The diodes wring out with high resistance, like 4meg one way and 2meg the other. Does anyone have or know where to get a manual or troubleshooting procedures for this drive? Thanks  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SIMOREG 6RA2625 SCHEMATICS. | GPena | Servo Motors and Drives | 2 | 07-22-2011 09:09 AM |
| Need Help!- 6m spindle drive info | dave3431 | Fanuc | 0 | 08-28-2009 10:49 AM |
| Need Help!- General Numeric (Fanuc) Spindle Drive info? | lavrgs | Tree | 8 | 06-02-2009 11:58 PM |
| SIMOREG 6RA2625-6DV57 | rock0 | Servo Motors and Drives | 0 | 12-08-2008 06:51 AM |
| Siemens drive problem | bigtomt | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 02-27-2006 07:38 PM |
| | |
Linear Mode
