Blast from the past Ge550/HNC - CNCzone.com-The Largest Machinist Community on the net!

07-10-2010, 04:05 PM

JR1050

Join Date: Jul 2006

Location: usa

Posts: 57

Blast from the past Ge550/HNC

permalink

Ok,before you all start rolling around laughing at my pet dinosour.....I picked up two HNC's for cheap with the intention of retrofitting at least one of them.Right now,I need one of them running.They have GE550 nc controls on them.I have one of them up and jogging,but no MDI or auto movements or commands.I suspect there is some sort of an inhibit coming from the hardinge
plc.The 6th led from the bottom of the isloation decoder board is lit.The prints leave alot to be desired..

Any one have experience with these beasts?Suggestions on where to look?Thanks

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- hardinge hnc with ge550 not working	Daniel Wilcox	Hardinge Lathes	14	11-16-2009 10:10 PM
Need Help!- Cannot go past 50 ipm!	greenene	Controller & Computer Solutions	9	11-05-2008 11:26 PM
Need Help!- Cannot go past 50 ipm!	greenene	Controller & Computer Solutions	1	11-04-2008 03:37 PM
CncZone - Blast from the past	Switcher	CNCzone Club House	1	10-08-2008 05:17 PM
Air Blast	jybute	Haas Mills	6	12-15-2007 07:14 AM

All times are GMT -5. The time now is 10:35 PM.