Hardinge Collet, Tap Adapter and Drill Bushing Tray - CNCzone.com-The Largest Machinist Community on the net!

HelicopterJohn · #1 04-22-2010, 06:42 AM

Hi,

I tried for some time to find a used collet tray for my Hardinge HC Chucker.

It apprears that the usual configuration when shipped is only one tray while the cabinet was fitted with 2 brackets for trays.

I decided to make my own. I programmed the parts utilizing ONECNC XR3. While I was in the design process I decided to make some holes for holding my Hardinge Tap Adapters and Hardinge Drill Bushings.

Here is a few pictures for your amusement.

JP Hardinge · #2 04-22-2010, 08:18 AM

Very cool.

HelicopterJohn · #3 04-22-2010, 08:54 AM

Hi,

Thanks for the positive comment. It is just one of the many projects I had laying around waiting to be done. It finally made it to the top of the list.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1/4 to 1/8 collet adapter?	CRFultz	DIY-CNC Router Table Machines	6	04-17-2010 01:54 AM
5C Collet Adapter For TL	Geof	Haas Lathes	12	12-03-2009 02:40 PM
Collet Adapter Bushing 1/4-1/8 Inch Shank	BJenkins	WoodWorking	0	05-04-2008 10:55 AM
Another Source for Collet Bushing Adapters	HayTay	DIY-CNC Router Table Machines	1	03-31-2006 03:53 PM
collet adapter	truman	General Metalwork Discussion	5	03-24-2006 08:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)