Try the following. Shut off machine, hold "P" and "Can" together and restart machine.Hold untill startup is complete. Then try to re-home.
-
Talent 8/52
oi-TC control
Everything was working fine yesterday.
Today when I powered up X homed fine.
Z gave a alarm 500, Z overtavel.
Not sure how to troubleshoot this.
I'm looking at the censors in the back but and not sure how they work with the parameters. I see two ramped sensors. the sensor falls off the ramp about .100 before the overtravel alarm.
Thanks for any help.
Sure would like a trouble shooting guide for this machine!
Similar Threads:
Try the following. Shut off machine, hold "P" and "Can" together and restart machine.Hold untill startup is complete. Then try to re-home.
-
That did the trick : )
Thanks for your help!!!
dear sir i use fanuc oi tc.machine indicate alram no500 xaxis over travel.plz guide me.
machine can not homing
best regards
Just wanted to confirm that the P/O + CAN (P and O are same button) solution worked on our Hardinge T42 with 18T fanuc control when it had this odd 500 X+ over travel error. Thank goodness!