| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Hard and High Speed Machining Discuss Hard and High speed Machining here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-13-2007, 10:43 AM
| |||
| |||
I'm having a problem with a high speed vertical grinding centre. When I run the program in AI Nano there is a hesitation at the start point of the diameter. It slows down so much that it leaves a witness line all the way up one side of the hole. The control is an Fanuc 18i-MB on a Chevalier VGC. I have tried to simulate the hesitation on a First V43 high speed mill and a Dahlih MCV by changing the parameters to match, but have not been able too. Does anyone have a suggestions that I can look at to try and rid the machine of the hesitation??    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HSM Functions AICC,AI NANO, HPCC, RISC CARD etc..... | bjk1903 | Fanuc | 7 | 01-04-2008 12:31 PM |
| hesitation after m code | AndyB | Fadal | 5 | 06-12-2006 09:59 AM |
| Nano Interpolation vs 104/D | TDavid | Fadal | 7 | 03-30-2006 06:36 PM |
| | |
Linear Mode
