You have multiple issues going on.
You need to look at your Misc intigers on the misc values tab on the first page of an op parameters window. You will find I think that misc integer #1 needs to be a 2 to get G54's and then you can change the offset in the planes tab.
The three block delete lines are caused by the misc integer issue.
You need to set up your machine def and your control def. Call your reseller if you don't know about this.
I have a hard time believing a drill and bore routine can be 62k of program.
I could believe it if you were interpollating...
If you want to use caned cycles...turn them on in the machine def and in the post. Once again, if you don't know how, call your reseller.
And ...apparently, your maintanance has expired.
There isalso a lot of help to be had on the Emastercam site.