| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-29-2010, 12:36 PM
| ||||
| ||||
There are two M30 counters on the display of my MM2, question is how do you re-set them if you are going to use one as a prts counter, and I understand that both counter 1 and counter 2 need to be re-set seperately  |
|
#2
01-29-2010, 12:52 PM
| ||||
| ||||
| Scroll the blinking curser to the one you want to re set (Down arrows) and then push the "Origin" button..
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- CTR counters in Ladder Logic | Adam Rehorn | Fanuc | 0 | 08-07-2009 02:20 PM |
| Encoder counters & card | maxvovk | General Electronics Discussion | 0 | 10-04-2005 05:27 PM |
| | |
Linear Mode
