Tool ATC arm Origin

[Kool Parts]

So I just had my first tool change foul up. I think the tool came loose so when it was about a 1/2 inch from going in..it stopped.
I got both tools out and tried to do a recover. Now it wants me to move the ATC arm to Origin. (ATC fwd..ATC bwd). You can move it both ways but I dont know where it wants me to stop (origin)?
Anybody help while I am frantically looking for the manual.
Thanks,
Gary

[Kool Parts]

Got it..
Gary

[Delw]

this is funny cause sunday night I had the same thing. I was like WTF, had to come on to the zone and find a way to reset it. stupid me I was setting up the machine and not watching the buttons and it seemed I hit dryrun. thats why the tool arm moved extreamly slow. couldnt get it to move faster no matter what I did. gave me errors when I hit the reset button. so followed the directions and ran slow again. just happened to glance at the screen and saw the dry run light on. turned it off and worked fine. shut the machine off and went home. almost 2 hours dicking with that thing and all it was, was fat finger syndrom.


Delw