need to probe bore with boss in the middle - CNCzone.com-The Largest Machinist Community on the net!

1ctoolfool · #1 10-15-2009, 12:47 PM

need a probing routine to find a bore center but there is a boss in the middle of the bore which prevents using a standard bore probe routine.
Using Marposs, please help.
thanks

pit202 · #2 10-15-2009, 01:20 PM

there is a cycle in renishaw macros , maybe in marposs too, look in the manual for this :

Integrexman · #3 10-17-2009, 08:01 PM

I have been doing a lot of on machine probing lately. Here is a link to a program I made that uses the Renishaw inspection plus macros and XYZIJK Point data from my CAM system to make a program to inspect the part. http://cncwrite.com/cmm.php

Best viewed with VLCMedia Player.
http://www.integrexmachinist.com/Vid.../ProbeFace.mpg

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Newbie- Using tool probe to get bore size.	whitey machine	Haas Mills	2	08-19-2009 12:34 PM
Middle NC	xclr82xtc	Mentors & Apprentice Locator	0	07-02-2009 05:36 PM
What's the peg in the middle of the X-axis?	MechanoMan	Taig Mills & Lathes	17	06-17-2009 05:41 PM
starting from the middle of a program	panaceabea	Haas Mills	8	03-27-2009 06:31 PM
Boss 6 Motor Pulley Options - 5/8" to 1/2" Bore	snakebit95	Bridgeport and Hardinge Mills	0	08-11-2006 02:03 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)