Need Help! HAAS VF2 SPINDLE AND ORIENTATION PROBLEMS (237 Error) - CNCzone.com-The Largest Machinist Community on the net!

09-26-2009, 10:45 AM

dkglass

Join Date: Sep 2006

Location: USA

Posts: 2

HAAS VF2 SPINDLE AND ORIENTATION PROBLEMS (237 Error)

permalink

I have a Haas VF2 with umbrella style tool changer. I just replaced the encoder belt because it would not orient when changing tools. The belt was worn out. I followed HAAS INSTRUCTIONS but It didn't work. Not only does it not orient but now when I turn on the spindle the speed goes wide open and then stops and gives a 237 error (spindle following error) .
Can anybody help me figure this out. Thanks

Last edited by dkglass; 09-26-2009 at 02:47 PM. Reason: Change Heading

Tags

237 error, encoder belt, spindle orientation

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Haas GR510 problems?	JoBwan	Haas Mills	19	06-06-2011 08:54 AM
Need Help!- HAAS HS-1 Pallet Change problems	cweiss	Haas Mills	3	07-30-2008 04:42 AM
Problems with Haas spindle bearings?	barryhc	Haas Mills	13	07-28-2008 02:43 PM
Haas TM-1P Rigid tapping problems	dapoopta	Haas Mills	3	03-18-2008 08:39 PM
coolant problems on Haas supervf4	binzer	Haas Mills	2	07-26-2007 12:13 PM

All times are GMT -5. The time now is 08:28 PM.