DNC of large files on the TM2 - CNCzone.com-The Largest Machinist Community on the net!

MeTri · #1 09-16-2009, 08:29 AM

Hi guys,

I'm trying to send a large file from MasterCam X3 to the Hass. The file is larger than the Hass memory and it just won't accept it. I know I should be able to do the transfer block wise, but I just can't figure out how to do it. Any help would be great. Thanks.

Brian

dcoupar · #2 09-18-2009, 05:39 PM

Used to be you pressed the MDI/DNC key twice to get to DNC mode. I would recommend starting out in SINGLE BLOCK, then CYCLE START. You have to have a M02 at the end of the program (not M30).

WGJ · #3 09-19-2009, 08:04 AM

I hate to even ask this, but I have to. I can only assume that your machine is older than the models with the standard USB port???

MeTri · #4 09-19-2009, 07:41 PM

No USB port... I'll try the key combination. I think my problem is more on the mastercam side, but I'll try that. Thanks

Brian

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DNC Large Files 12 MB and bigger Problem	Rocko1	Haas Mills	0	07-14-2009 12:09 PM
How to Transfer Large Files?	adsxy	General CAD Discussion	3	09-13-2008 06:35 AM
Large Files and a VF-1 2002	frogger	Haas Mills	10	10-06-2007 07:45 PM
VBA - Import & Split large files	NeoMoses	Visual Basic	0	11-12-2006 02:38 PM
Downloading large files	moldcore	Milltronics	11	05-09-2006 10:10 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)