MM2/SMM2 dimension needed - CNCzone.com-The Largest Machinist Community on the net!

TravisR100 · #1 09-03-2009, 02:56 PM

If anyone here has a MM2 or SMM2, I could sure use some help with a dimension. I'm going to be placing this mill with the back of it up against a wall. There is a door on the back of the machine which needs to be accessible. To access the back of the machine I'm going to be putting a door in the wall that it will be backed up against. What I need is the length from the leftmost protrusion of the machine on the left side to the beginning of the door opening on the back of the machine. Once I have this I can cut the hole in the wall for the new door.

My local HFO can't seem to find this information anywhere. Anyone out there with a machine and a tape measure that could help?

JoBwan · #2 09-03-2009, 07:35 PM

You may also put some thought into a vent in the door. If a vent is not an option, you may want to leave the machine out far enough so that the electronics get plenty of cool air. HEAT SEEMS TO BE THE # 1 CAUSE FOR ELECTRONIC FAILURES. Just something to think about.

TravisR100 · #3 09-03-2009, 08:05 PM

Thanks, I'll keep that in mind.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Looking for Gerber Dimension 200	gio666	CNCzone Club House	0	06-01-2008 09:32 AM
Looking to buy a gerber dimension 200	gio666	Canadian Club House	0	05-27-2008 02:39 PM
SL-30 dimension needed	rka	Haas Lathes	7	03-31-2008 09:24 PM
Need Help!- Changes to Dimension Preference	SPEEDRE	Solidworks	2	02-01-2008 12:03 PM
Gerber Dimension 200	teemac	Commercial CNC Wood Routers	1	04-21-2007 11:30 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)