| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
02-01-2009, 08:23 PM
| |||
| |||
| We have a VF0 purchased in 2000, the X and Y covers have never removed to clean out chips. They were removed to check on a ball screw noise and there was not any significant build up of chips. The Z covers were removed to repair damage and no chip build-up was found. However, we also have MiniMills and these are really bad for packing chips up behind the Z axis covers. I think they need cleaning about every three years or so.
__________________ An open mind is a virtue...so long as all the common sense has not leaked out.  |
|
#3
02-03-2009, 07:41 AM
| ||||
| ||||
| Open and Clean at least annually. Depending on the size of chips or swarf it may need to be done more often. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| way covers | cruizer67 | Tormach PCNC | 32 | 11-10-2008 08:47 PM |
| Way covers !! Super x3, where and $ ? | scyan | Syil Products | 16 | 10-05-2007 11:51 PM |
| IH way covers | Runner4404spd | Industrial Hobbies (Support forum) | 7 | 09-19-2007 02:35 PM |
| Way Covers For SX3 | Old Megawatts | Syil Products | 9 | 06-15-2007 11:03 AM |
| BP Series II CNC way covers | unterhaus | Bridgeport and Hardinge Mills | 3 | 12-26-2006 09:09 AM |
| | |
Linear Mode
