VF-OE Mastercam X3 post

[sportbikeryder]

.

[Gmaan]

With Mastercam you can make as many view/tool planes as required. What ever you create in Solid works, should not matter to Mastercam. You as the programmer must decide where the face origin will be on the part, if not defined from the part print. Is the part complicated, surfacing, and draft cuts? or is it just a simple part with pockets, holes, ect? If it is simple, why draw it solid works, Mcam is much easier to draw with, and you do not have to worry about importing models, or rev changes.
Tool length offsets, is the setting on the Haas control set to "length uses work", on or off? This will change your measured length offsets. I am not sure what setting number it is but look in the setting page and you will see what I am talking about.