Results 1 to 2 of 2

Thread: Tool Change Recovery VF3 Umbrella

  1. 11-07-2008, 12:35 PM #1
    cncmaintenance
    cncmaintenance is offline
    Registered cncmaintenance's Avatar
    Join Date
    Aug 2008
    Location
    USA
    Posts
    15
    Downloads
    0
    Uploads
    0

    Tool Change Recovery VF3 Umbrella

    What is the procedure for a tool change recovery with a 1993 model VF3?
    It does not have a ATC Recovery Button.

  3. 11-07-2008, 01:05 PM #2
    wms
    wms is offline
    Moderator wms's Avatar
    Join Date
    Mar 2003
    Location
    United States
    Posts
    940
    Downloads
    0
    Uploads
    0
    Zero Return(Mode) >"Z"(button)> Zero Single Axis(button).
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

« vr-11 A & B interpolation | Alarm 161 on VF-0 »

Similar Threads

  1. X3 Tool change... Ugh!
    By AirHog in forum Benchtop Machines
    Replies: 8
    Last Post: 12-18-2010, 02:07 PM
  2. Tool change ?
    By Blacksunshine in forum DIY CNC Router Table Machines
    Replies: 3
    Last Post: 07-09-2008, 11:48 PM
  3. Very slow tool change on Tool Room Mill
    By Capt Crunch in forum Haas Mills
    Replies: 3
    Last Post: 12-21-2007, 01:20 PM
  4. How to change Tool change position(About MAZATROL T1 control)
    By liushuixingyun in forum Mazak, Mitsubishi, Mazatrol
    Replies: 5
    Last Post: 07-07-2007, 03:58 PM
  5. Tool change
    By lilricky2 in forum BobCad-Cam
    Replies: 2
    Last Post: 06-03-2006, 02:00 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.