Sharing my Haas vector drive schematics

[tayfunk]

Dear friends
I saw that every friend in this section of the forum had some problem with the Haas spindle vector drivers. I also had lived problems with this module. My problem had been a huge one; a considerable part of the board had been burnt out. For this reason I had been obligated to draw its electronic schematic diagram all over. Referring to many problems around, I decided to put my schematics for share. However, there may be a few mistakes on the diagrams, so be careful... If you happen to find some problem on it. Please feel free to inform me about it. It shall be fixed as soon as possible. The link is given below.

http://www.edim.com.tr/index.php?opt...download&cid=3


Best regards.

Tayfun Kusluoglu

[ilbebach]

Real nice of you Tay

But I am unable to link to that...
can you check the link again please ??

MJM

We have Haas vector drives and sure would like to see what you prepared...

[Donkey Hotey]

Wow! Thank you! I really could have used that about a year ago. I learned most of what I now see on that schematic. In the end, it was a problem that was not fixable (bad circuit board) but I spent a lot of time learning what everything did.

[tayfunk]

Thank you ilbebach,

There was a problem at our host yesterday.

Would you check again the link?

There are 15 dowloands performed succesfully.

I hope you can reach the schematic diagrams after now.

Best regards

[tayfunk]

Dear Greg

Thank you for your kind attention.

I was ın luck. I could fix my problem. I repaired my pcb board.

J7 and J5 connectors are too important. Belong to J5 cable side has to never connected to J7.

So, my friends please be careful. Otherwise, you obliged to repair your pcb.

Your intensive attentions encouraged me.

In a near future, I will issue Ingersoll-Rand Compressor control board and Yaskawa USASEM-08TF22 motor encoder electronic schematic diagrams.

Best regards,

Tayfun

[ilbebach]

Yeah I got it ok .

Thanks again for the schematics .

regards
MJM

[tayfunk]

I am glad to meet you in the forum

[GFerreira]

Thanks so much!

We have two VF-5s with 40HP Vector drives. The board isn't exactly the same but it for the most part, and the rest is functionally similar. We had to replace one last year and now the other one has gone down... both at 4 years! Not the most reliable machines...

Your schematic has been most valuable and the problem is almost pinned down.

Thank you again!