Question about HAAS Program with macros - CNCzone.com-The Largest Machinist Community on the net!

mgb1974 · #1 06-12-2008, 02:50 PM

I am beating my head in on this program. Everytime I runthe program(graph mode and actually running it) stops at line 11 and just sits there and it says "running" in the key line.

Someone take a look at it and see if they see any errors I have missed.

Thanks

Haas_Apps · #2 06-12-2008, 04:06 PM

Originally Posted by mgb1974

I am beating my head in on this program. Everytime I runthe program(graph mode and actually running it) stops at line 11 and just sits there and it says "running" in the key line.

Someone take a look at it and see if they see any errors I have missed.

Thanks

The issue is with the WH[ #109 GE 0] DO1 loop. I ran this a few times with a lot of problems. Take a look at your tool diameter offset for tool 15. everytime I run this I get a value put in there of 47.3978. I do not understand why you are writting to the offset.

I you describe what you are attempting to do many people will be able to help you better.

mgb1974 · #3 06-13-2008, 07:12 AM

problem solved! Thanks for the input

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Having trouble loading program using Mastercam"s Cimcov5 in my Haas	Robert Timby	Mastercam	3	01-19-2008 06:25 PM
Trying to load program using Cimco into a Haas	Robert Timby	Haas Mills	8	01-18-2008 02:21 PM
Macros on the Haas	CJH	Haas Mills	8	08-27-2007 12:09 AM
TL1 Haas intuitive program restarts?	elaganis	Haas Mills	4	02-02-2007 03:06 PM
haas program question	cncsdr	Haas Mills	20	09-17-2005 01:17 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)