options on a machine

[ssrmr2]

John,

depending on the pivot point for the PCool and the amount of verticle control over the nozzle, you might be able to make an extension to reach the other side of the cutter.

I say "MIGHT" because of several reasons:

1st: as you get farther away from the pivot point the you will either need to increase/decrease the verticle movement of the nozzle. This is where my second caviat comes in.

2nd: if you can get an additional nozzle " tube and fitting" and extend that to the other side of the cutter on the same "plane and angle" then it may be do-able.

I think the challenging part will be adapting a fitting at the pivot point.

I will have to add this much later.

steve