| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-25-2008, 09:33 PM
| |||
| |||
Caught me by surprise!!! Was milling a pocket out, then went straight into the next tool, and totally skipped the M6 for the drill cycle. Is this the ghost that some seem to mention from time to time? Smitty  |
|
#2
05-26-2008, 02:09 PM
| ||||
| ||||
| That is disconcerting! Were there any special circumstances? Does it run ok after that? Did you happen to have two M codes on one line (as a manual edit in)?
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#4
05-28-2008, 12:23 AM
| |||
| |||
| Yea, my Tool changer is 6'2" 230#. I was coping a file, and missed a few lines, took a phone call to realize the stupid button was on again! |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ground Loops and Missed Steps | cbcnc | General Electronics Discussion | 34 | 03-16-2008 02:34 PM |
| Missed steps and back EMF question | wjfiles | General CNC (Mill and Lathe) Control Software (NC) | 3 | 08-14-2006 08:11 AM |
| Missed Steps | fool | Machines running Mach Software | 11 | 04-04-2006 06:51 PM |
| Missed Steps - A curse or manageable? | andy_ck87028 | Stepper Motors and Drives | 3 | 07-20-2005 05:47 PM |
| Problem with error or missed steps or something? | rustyolddo | TurboCNC | 18 | 07-10-2005 08:51 AM |
| | |
Linear Mode
