| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-05-2008, 10:12 AM
| |||
| |||
I couldn't find a Haas lathe forum so I'll post here. I have an SL-30 that we barfeed on. I have to manual change the tailstock hold point for each part that we run. Is there a way to change setting 107 in the program with macro or even g10?
__________________ No matter how good you are, there is always someone better!!!  |
|
#2
05-07-2008, 01:44 PM
| |||
| |||
| You can rapid and feed the tailstock as a B axis instead. If you feed (G01 G98 F10.) from a rapid clearance point, it will work. According the my manual here, the F value doesn't matter, it will only move at one feed rate. Just check your SL-30's manual in the "operation" section, then find the tailstock section. This will work without using setting 107. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New to the family and question about HAAS | dark-dna | Haas Mills | 10 | 09-29-2007 04:10 PM |
| Haas TM-2 control question | Zeekh | Haas Mills | 1 | 03-14-2007 09:14 PM |
| Haas service question | PBMW | Haas Mills | 1 | 09-04-2006 09:00 PM |
| Haas SL10 Tailstock problem | metal surgeon | Haas Mills | 4 | 09-04-2006 11:24 AM |
| haas program question | cncsdr | Haas Mills | 20 | 09-17-2005 12:17 AM |
| | |
Linear Mode
