vf-3 through a 9 ft high 10 ft wide door? - CNCzone.com-The Largest Machinist Community on the net!

mls · #1 04-20-2008, 06:22 PM

I want to buy a haas vf-3 can I get it though a door that is 9 ft high by 10 ft wide

Thanks Mike

ducesrwld · #2 04-20-2008, 09:05 PM

side mount tool changer or not will make a big difference on the height?

mls · #3 04-21-2008, 04:23 AM

there is no side mount itis the umbrella

Daves 41 · #4 04-21-2008, 10:33 AM

Should be no problem with good movers did it with a VF3SS in Nov.
Dave C

fourperf · #5 04-21-2008, 01:01 PM

I dont know what the size difference is between a vf2 ad vf3 but I squeezed my vf 2 through a 84 inch by 84 inch opening

http://www.cnczone.com/forums/showth...ourperf&page=3

look at post 29 for pictures

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3/4 wide rack	eloid	DIY-CNC Router Table Machines	0	01-06-2008 10:33 AM
High Torque , High Bandwidth Motor or Servo	mastabib	Benchtop Machines	0	09-26-2007 02:09 AM
searching far and wide	Gandalf	Deckel, Maho, Aciera, Abene Mills	5	08-31-2007 09:35 AM
8' high mill through a 7' high door?	iandm	Bridgeport and Hardinge Mills	10	11-21-2006 08:12 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)